facebook_icon

Clad Metals

Clad Combinations

SS / AL / SS AL / CRS / AL Cu / CRS / Cu
Bronze / CRS / Bronze Brass / CRS / Brass Cu / SS / Cu
Bronze / SS / Bronze Brass / SS / Brass Cu / SS / Ni
CRS / AL / CRS SS / Cu / SS AL / Cu
Cu / SS Ni / SS AL / CRS / Cu / Ni
CuNi / Cu / CuNi Bronze / CRS / Cu AL / CRS
Slitting Capabilites
Gauge Range
.002-.125 (inches) *Dependant upon metal combinations
Width Range
.250-32.00 (inches) *Dependant upon metal combinations
ID
8, 12, 16 or 20 (inches)
OD
60 (inches) maximum per application
Coil Weight
5,000 pounds standard per application
Cut-to-Length Capabilites
Gauge Range
.015 to .060 (.381 - 1.524 mm)
Width Range
.015 to .060 (.381 - 1.524 mm)
Length Range
12 ” - 144 ” (305 - 3,658 mm)

Standard Tolerances

Gauge

0.0829 - 0.072 +/- 0.004 0.0259 - 0.011 +/- 0.0015
0.0719 - 0.040 +/- 0.003 0.0109 - 0.007 +/- 0.001
0.0399 - 0.026 +/- 0.002 0.0069 - 0.004 +/- 0.0005

Length

Flat cut lengths run from 6 -8 feet. Other lengths in this range can be cut as multiples of the 6 -8 feet in order to avoid scrap.

Camber

  • Camber is to be determined by placing an 8ft. straight edge against the concave edge of the strip.
  • Camber is the greatest deviation of the side edge from a straight line; the measurement being taken on the concave side with a straight edge.

Tempers

  • Annealed
  • 1/4 Hard
  • 1/2 Hard
  • 3/4 Hard
  • Full Hard

Finishes

  • Standard Mill
  • Preferred Mill
  • 1 or 2 Sides Bright
  • 1 or 2 Sides Matte

Applications

  • Bearings
  • Gaskets
  • Battery Cells
  • Lead Frames
  • Springs
  • Transition Joints
  • Contact Arms
  • Heat Shields
  • Heat Exchangers
  • Wire/Cable Shielding